Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

911STROBE + Separate Power Source

Use this tutorial to power the LEDs from a separate power source (NOT the receiver) using the 911STROBE™ 14 LED Controller.

This tutorial uses the 4 wire power plug and RX Pass-Thru™ included with the 911STROBE™ 14 LED Controller.

Remove Blue Wire

Step #1:

Remove the blue wire from the 4 wire power plug.

To remove connector terminals from the connector housings use an XACTO knife.
Plug Into RX Pass-Thru

Step #2:

Plug the 3P connector housing with 2 wires into the included RX Pass-Thru™, black-black; white-white.
Plug Into 911STROBE LED Controller

Step #3:

Plug the separate power source positive (+) lead into the top pin of PWR, and the negative(-) lead into the bottom pin of PWR.

Plug the 2x2P connector housing (notch up) into the other set of PWR and AUX channels, black-bottom-PWR; white-bottom-AUX; grey-top-AUX.
Plug Into RX

Step #4:

Plug the RX Pass-Thru™ and 3P connector housing with 1 wire into the receiver's throttle and auxiliary channels.

Tutorial Complete!