Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

Dual RPS

Use this tutorial to independently switch power to the 2 LED banks (LED1-6 & AUX1-4) on the Standard 10 LED Controller (#5051) using two different toggle switches on the transmitter.

This tutorial uses the 3 wire power plug included with the Remote Power Switch.

Separate 3P Wire

Step #1:

Remove the white wire from the 3P connector housing and insert it into a 2P housing as shown.

If no 2P housing is available use heat shrink to insulate the connector terminal.

To remove connector terminals from the connector housings use an XACTO knife.
Plug 3P Into RPS

Step #2:

Plug the 3P connector housing into one RPS, black-white; blue-red.

Plug the 2P connector housing into the second RPS, white-white.
Plug Into LED Controller

Step #3:

Remove the jumper on the AUX pins.

Plug the 2x2P connector housing into the PWR & AUX channels with the notch UP.

PWR Top Pin - Blue
PWR Bottom Pin - Black
AUX Top Pin - none
AUX Bottom Pin - White 
Plug Into RX

Step #4:

Plug each RPS into separate channels on the receiver.

Discard or save the LED Controller jumper.

Tutorial Complete!