Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

NIGHTFLY + Separate Power Source

Use this tutorial to power the LEDs from a separate power source (NOT the receiver) using the NIGHTFLY™ 14 LED Controller.

This tutorial uses the 4 wire power plug included with the NIGHTFLY™ 14 LED Controller.

Remove Blue Wire

Step #1:

Remove the blue wire from the 4 wire power plug.

To remove connector terminals from the connector housings use an XACTO knife.
Plug Into NIGHTFLY LED Controller

Step #2:

Plug the separate power source positive (+) lead into the top pin of PWR, and the negative(-) lead into the bottom pin of PWR.

Plug the 2x2P connector housing (notch up) into the other set of PWR and AUX channels, black-bottom-PWR; white-bottom-AUX; grey-top-AUX.
Plug Into RX

Step #3:

Plug the other ends of the 4 wire power plug into the receiver's two channels tied to 2-position switches on the TX.a

Tutorial Complete!