Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

RCL104 Step by Step

4 LED SYSTEM FOR RPM FRONT/NARROW ROOF CANISTERS [3MM, 4”]

STEP 1 STEP 2
Locate the four 4” Wire Extensions, four 3mm White LEDs, four 2P housings and one 4x2P housing. Remove housings from each end of the 4” wire extensions. Following Plug and Play Connector – Heavy Duty Off-Road Use Assembly Instructions assemble the LED side of each wire extension. Then insert each wire extension into the 4x2P housing keeping all the positive-blue on one side and all the negative-black on the other. Picture shows this step completed.
STEP 3 STEP 4
Insert LEDs into RPM LED Canisters. If desired, wires can be twisted together prior to installing LEDs into canisters. Picture shows this step completed. Using the provided mounting base and zip tie, mount the Standard 10 LED controller to the RPM front bumper. Plug the 4x2P housing into AUX1-4 on the LED controller (blue-top-positive; black-bottom-negative.) Plug the 2P housing side of the RX Plug wire into PWR (red-top-positive; black-bottom-negative) and the 3P RX end into any open channel on the RX. If no extra channels are available use a RX Pass-Thru™ (#RCL5074) or a Y-harness. Picture shows this step completed.
Before you begin installation onto the vehicle/body: completely read through these instructions, setup/configure your lighting system, and test it to ensure proper operation. Before ever applying power to the LEDs check & double-check your wire connections to ensure the LEDs are plugged into the right channels on the LED controller. LEDs blown due to incorrect installation wiring are not covered by warranty. Connecting LEDs directly to power will blow them immediately.
WARNING: LED lights are designed to be used in extreme nighttime and low visibility running environments and are very high output. DO NOT look directly into beam.
WIRING DIAGRAM