Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

RCL106MB Step by Step

6 LED SYSTEM FOR RPM FRONT/NARROW ROOF & TAIL CANISTERS [3MM, 4”/24”]

STEP 1 STEP 2
Locate the four 4” Wire Extensions, four 3mm White LEDs, four 2P housings and one 4x2P housing. Remove housings from each end of the 4” wire extensions. Determine LED colors by plugging 1-Channel RX Plug into PWR & AUX (notch up) and into any RX channel, and each LED into LH, LF, RF, or RH channels. Following Plug and Play Connector – Heavy Duty Off-Road Use Assembly Instructions assemble the LED side of each wire extension. Then insert each wire extension into the 4x2P housing keeping all the positive-blue on one side and all the negative-black on the other. Picture shows this step completed.
STEP 3 STEP 4
Insert LEDs into RPM LED Canisters. If desired, wires can be twisted together prior to installing LEDs into canisters. Picture shows this step completed. Locate the two 24” Wire Extensions, two 3mm Red LEDs, and two 2P housings. Remove housings from one end of the 24” wire extensions.
STEP 5 STEP 6
Following Plug and Play Connector – Heavy Duty Off-Road Use Assembly Instructions assemble the LED side of each wire extension. Insert LEDs into RPM LED Canisters. If desired, wires can be twisted together prior to installing LEDs into canisters. Use zip ties or aluminum tape to secure wires together. Picture shows this step completed. Using the provided mounting base and zip tie, mount the microBRAKE™ 6 LED controller to the RPM front bumper. Plug the 4x2P housing into LH, LF, RF, and RH channels on the LED controller (blue-top-positive; black-bottom-negative.) Plug the 2x2P housing side of the 1-Channel RX Plug into PWR & AUX (notch up) and the 3P end into the RX Pass-Thru™. Plug the ESC or throttle servo into the RX Pass-Thru™ and the RX Pass-Thru™ into the RX throttle channel. Wire extensions from the brake lights can be plugged into the LB & RB LED channels. The final 4x2P housing can be used to combine the connectors on the PWR side of the controller; make sure to maintain correct polarity (blue - top pin - PWR; black - bottom pin - PWR; white - bottom pin - AUX) when swapping. Pictures show this step completed.
RX PASS-THRU INSTALL COMPLETED
The RX Pass-Thru™ is shown here tucked inside a waterproof radio box. Wires are twisted together to keep them neatly tucked away during off road bashing.
Before you begin installation onto the vehicle/body: completely read through these instructions, setup/configure your lighting system, and test it to ensure proper operation. Before ever applying power to the LEDs check & double-check your wire connections to ensure the LEDs are plugged into the right channels on the LED controller. LEDs blown due to incorrect installation wiring are not covered by warranty. Connecting LEDs directly to power will blow them immediately.
WARNING: LED lights are designed to be used in extreme nighttime and low visibility running environments and are very high output. DO NOT look directly into beam.
WIRING DIAGRAM