RCL5024 Step by Step

911STROBE™ 14 LED POLICE SYSTEM [5MM, 14”]

STEP 1	STEP 2

Locate the fourteen 14” Wire Extensions, four 5mm White LEDs, four 5mm Blue LEDs, six 5mm Red LEDs, and fourteen 2P housings. Trim LED leads and follow Plug and Play Connector – Standard Use Assembly Instructions –OR– Remove housings from one end of the 14” wire extensions and follow Plug and Play Connector – Heavy Duty Off-Road Use Assembly Instructions to assemble the LED side of each wire extension. Determine LED colors by plugging 2-Channel RX Plug into PWR & AUX (notch up) and into any RX channel, and each LED into LBK or RBK channels.	Install the LEDs through the body using the included LED holders & rings or behind the body without holders. Detailed instructions for both methods can be found HERE.

STEP 3	STEP 4

Twist wires going to the same location together to keep wires neatly tucked away. Using aluminum tape and zip ties and bases (saving a set for mounting the LED Controller) route all wires to a central location where the final zip tie and base should be used to secure the LED controller. Mount the 911STROBE™ 14 LED controller on the side of the body for easy access and to prevent damage from roll over.	Plug the 2x2P housing side of the 2-Channel RX Plug into either PWR & AUX (notch up) then plug the connector with 3 wires on the other end into a RX Pass-Thru™ along with the throttle servo or ESC; and then into the RX throttle channel. Then plug the connector with 1 wire into the RX auxiliary channel tied to the two-position switch on the TX that you want to use. Wire extensions from the headlights can be plugged into any H1 or H2 LED channel, taking note of R and L for the headlight strobe feature. Roof strobes can be plugged into R1 thru R4 channels, taking note of R and L for desired alternation. Brake lights can be plugged into RBK & LBK LED channels. Wire extensions should be plugged into LED channels following polarity blue-top-positive; black-bottom-negative. Power up the LED system and configure the DIP switches on the 911STROBE™ 14 LED controller for correct LED operation.

Before you begin installation onto the vehicle/body: completely read through these instructions, setup/configure your lighting system, and test it to ensure proper operation. Before ever applying power to the LEDs check & double-check your wire connections to ensure the LEDs are plugged into the right channels on the LED controller. LEDs blown due to incorrect installation wiring are not covered by warranty. Connecting LEDs directly to power will blow them immediately.

WARNING: LED lights are designed to be used in extreme nighttime and low visibility running environments and are very high output. DO NOT look directly into beam.

WIRING DIAGRAM

UniversalR/C LED Systems

Our Newsletter

RCL5024 Step by Step

911STROBE™ 14 LED POLICE SYSTEM [5MM, 14”]

Universal
R/C LED Systems