LED CONTROLLER - STANDARD 10 LED

DOWNLOAD- PDF Tech Sheet

Use to connect up to 10 LEDs directly to any available channel on the RX (receiver).

Pins can be soldered to for a hardwired connection. Pins can also be removed if they will not used.

Plug the Standard 10 LED Controller into any available channel on the RX, or use any 3.6-7.4VDC power source. If no extra channels are available on the RX use a RX Pass-Thru™.

Align BLUE wires with the top side of the Standard 10 LED Controller. 

LED CONTROLLER BANKS

1 LED 1-6 : HEAD, FOG, RUNNING, UNDER-GLOW, CONSTANT NAVIGATION

2 AUX 1-4 : BRAKE, LANDING, or ADDITIONAL CONSTANTS USING INCLUDED JUMPER

LED CONTROLLER CHANNELS

PWR 3.6-7.4VDC POWER INPUT (NEVER PLUG A LED IN HERE, USE ONLY TO LINK LED CONTROLLERS OR POWER THE LED CONTROLLER)

LED1-6 CONSTANTLY DRIVE ANY SINGLE LED, ALL CHANNELS ARE EXACTLY THE SAME (LED BANK 1)

AUX INPUT USED TO SWITCH AUX1-4 LED CHANNELS (ON/OFF USING RPS, ON/DIM USING EBS)

AUX1-4 CONSTANTLY DRIVE ANY SINGLE LED, ALL CHANNELS ARE EXACTLY THE SAME (LED BANK 2)

PINOUT LEGEND

 RESISTOR IN CIRCUITRY

 ELECTRICALLY CONNECTED

+ POSITIVE VOLTAGE FROM POWER SOURCE

- NEGATIVE GROUND FROM POWER SOURCE

R+ POSITIVE OUTPUT WITH INLINE RESISTOR

AR- NEGATIVE OUTPUT WITH INLINE RESISTOR (AUX SWITCHED)

A CONNECT TO GROUND TO POWER AUX1-4 LEDS (usually to the pin above it, using supplied jumper)

TOP PINOUT

BOTTOM PINOUT

WIRE COLOR (TO RX)

RED - POSITIVE (TOP PWR PIN ON LED CONTROLLER)
BLACK - GROUND (BOTTOM PWR PIN ON LED CONTROLLER)

WIRE COLOR (TO LEDs)

BLUE - POSITIVE
BLACK - GROUND