Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

RCL5410 Step by Step

10 LED RUNNING LIGHTS - AMBER [5MM, 14”]

STEP 1 STEP 2
Locate the ten 14” Wire Extensions, ten 5mm Amber LEDs, and ten 2P housings. Trim LED leads and follow Plug and Play Connector – Standard Use Assembly Instructions –OR– Remove housings from one end of the 14” wire extensions and follow Plug and Play Connector – Heavy Duty Off-Road Use Assembly Instructions to assemble the LED side of each wire extension. Determine LED colors by plugging RX Plug into PWR and the RX, and each LED into a LED1-6 channel. Install the LEDs through the body using the included LED holders & rings or behind the body without holders. Detailed instructions for both methods can be found HERE.
STEP 3 STEP 4
Twist wires going to the same location together to keep wires neatly tucked away. Using aluminum tape and zip ties and bases (saving one set for mounting the LED Controller) route all wires to a central location where the final zip tie and base should be used to secure the LED controller. Mount the Standard 10 LED controller on the side of the body for easy access and to prevent damage from roll over. Plug the 2P housing side of the RX Plug wire into PWR (red-top-positive; black-bottom-negative) and the 3P RX end into any open channel on the RX. If no extra channels are available use a RX Pass-Thru™ (#RCL5074) or a Y-harness. Wire extensions from the headlights and tail lights can be plugged into any LED1-6 or AUX1-4 channel with a jumper on AUX pins.
Before you begin installation onto the vehicle/body: completely read through these instructions, setup/configure your lighting system, and test it to ensure proper operation. Before ever applying power to the LEDs check & double-check your wire connections to ensure the LEDs are plugged into the right channels on the LED controller. LEDs blown due to incorrect installation wiring are not covered by warranty. Connecting LEDs directly to power will blow them immediately.
WARNING: LED lights are designed to be used in extreme nighttime and low visibility running environments and are very high output. DO NOT look directly into beam.
WIRING DIAGRAM