Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

RCL5412E Step by Step

ELECTRONIC HEAD/LANDING LIGHTS - WHITE [5MM, 14”]

STEP 1 STEP 2
Locate the two 14” Wire Extensions, two 5mm White LEDs, two 2P housings, and one 3x2P housing. Trim LED leads and follow Plug and Play Connector – Standard Use Assembly Instructions –OR– Remove housings from one end of the 14” wire extensions and follow Plug and Play Connector – Heavy Duty Off-Road Use Assembly Instructions to assemble the LED side of each wire extension. Install the LEDs through the body (or canopy) using the included LED holders & rings or behind the body (or canopy) without holders. Detailed instructions for both methods can be found HERE.
STEP 3 STEP 4
Twist wires going to the same location together to keep wires neatly tucked away. Remove housings from the other end of each wire extension and insert terminals into the 3x2P housing keeping both positive-blue on one side and both negative-black on the other. Using aluminum tape and zip ties and bases (saving one set for mounting the LED Controller) route all wires to a central location where the final zip tie and base should be used to secure the LED controller. Mount the LED controller on the side of the body for easy access and to prevent damage from roll over. Plug the Remote Power Switch into an available 3rd channel tied to a 2 position switch on the transmitter. Plug the RX Direct2LED™ into the Remote Power Switch following polarity red-red; black-white. Plug the 2x3 housing into RX Direct2LED™ aligning the blue wires with the ‘+’. If using with Standard 10 LED Controller (#RCL5051) use the 1-Channel RX Plug instead of the RX Direct2LED™.
Before you begin installation onto the vehicle/body: completely read through these instructions, setup/configure your lighting system, and test it to ensure proper operation. Before ever applying power to the LEDs check & double-check your wire connections to ensure the LEDs are plugged into the right channels on the LED controller. LEDs blown due to incorrect installation wiring are not covered by warranty. Connecting LEDs directly to power will blow them immediately.
WARNING: LED lights are designed to be used in extreme nighttime and low visibility running environments and are very high output. DO NOT look directly into beam.
WIRING DIAGRAM