Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

RCL5491 Step by Step

LED SINGLE - WHITE STROBE [5MM, 24”]

STEP 1 STEP 2
Locate the 24” Wire Extension, 5mm White Strobe LED, and 3x2P connector housing. Trim LED leads and follow Plug and Play Connector – Standard Use Assembly Instructions to assemble the LED side of the wire extension. Install the LED through the canopy using the included LED holder & ring or behind the canopy without a holder. Detailed instructions for both methods can be found HERE.
STEP 3 STEP 4
Twist wires going to the same location together to keep wires neatly tucked away. Using aluminum tape and zip ties and bases (saving one set for mounting the LED Controller) route all wires to a central location where the final zip tie and base should be used to secure the LED controller. Plug the RX Direct2LED™ into any open channel on the RX. If no extra channels are available use a RX Pass-Thru™ (#RCL5074) or a Y-harness. The wire extension from the strobe light can be plugged into any LED channel on the RX Direct2LED™. Remove the housing from the 24” wire extension and insert each terminal into the 3x2P housing keeping the positive-blue on one side and the negative-black on the other. Plug the 3x2P housing into the RX Direct2LED™ blue-top-+; black-bottom.
Before you begin installation onto the vehicle/body: completely read through these instructions, setup/configure your lighting system, and test it to ensure proper operation. Before ever applying power to the LEDs check & double-check your wire connections to ensure the LEDs are plugged into the right channels on the LED controller. LEDs blown due to incorrect installation wiring are not covered by warranty. Connecting LEDs directly to power will blow them immediately.
WARNING: LED lights are designed to be used in extreme nighttime and low visibility running environments and are very high output. DO NOT look directly into beam.
WIRING DIAGRAM