Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

RPS + Separate Power Source

Use this tutorial to power the LEDs from a separate power source (NOT the receiver) and switch power to the Standard 10 LED Controller (#5051) LED BANK 2 (AUX1-4) using a toggle switch on the transmitter.

This tutorial uses the 3 wire power plug included with the Remote Power Switch.

Remove Blue Wire

Step #1:

Remove the blue wire from the 3 wire power plug.

Remove the 2x2P connector housing and replace with a 2P connector housing.

If no 2P housing is available cut the second row from the 2x2P housing to convert it to a 2P housing.

To remove connector terminals from the connector housings use an XACTO knife.
Plug Into RPS

Step #2:

Plug the 3P connector housing into the RPS, black-black; white-white.
Plug Into LED Controller

Step #3:

Remove the jumper on the AUX pins.

Plug the separate power source positive (+) lead into the top pin of PWR, and the negative(-) lead into the bottom pin of PWR.

Plug the 2P connector housing from the modified 3 wire power plug into the AUX channel, black-top; white-bottom.
Plug Into RX

Step #4:

Plug the RPS into the receiver.

Discard or save the LED Controller jumper.

Tutorial Complete!