#5070 SYSTEM LINK CABLE

Use between any two LED controller's LINK or PWR channels to power both LED controllers from the same power source connected to ones PWR.

#5071 3AA BATTERY HOLDER

Install 3AA batteries for 24+ hour run times. Drill 3/16" hole in lexan for access to battery removal screw. Mount with double-sided tape.

#5072 9V BATTERY CLIP

Snap clip onto 9V battery, remove to turn lights off. INPUT VOLTAGE: 7-10V OUTPUT VOLTAGE: 6V MAX OUTPUT CURRENT: 400mA 

#5073 RX PLUG

Plug into any available channel on the receiver. LENGTH: 14"

#5074 RX PASS-THRU™

Electrically equivalent to a Y-harness. Also great for extending a RX channel outside the radio box.

#5076 2 CHANNEL RX PLUG

Plug into receiver channels corresponding to the signals you'd like the lights respond to, throttle & steering, throttle & power, power & landing, etc. If only one RX signal input is needed the signal wire for the second channel can be removed. LENGTH: 14"