Loading... Please wait...



Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

DO NOT look directly
into beam.

Our Newsletter

Subscribe to receive
New Product Release &
Promotional e-mails.

microBRAKE + Separate Power Source

Use this tutorial to power the LEDs from a separate power source (NOT the receiver) using the microBRAKE™ 6 LED Controller.

This tutorial uses the 3 wire power plug and RX Pass-Thru™ included with the microBRAKE™ 6 LED Controller.

Remove Blue Wire

Step #1:

Remove the blue wire from the 3 wire power plug.

Remove the 2x2P connector housing and replace with a 2P connector housing.

If no 2P housing is available cut the second row from the 2x2P housing to convert it to a 2P housing.

To remove connector terminals from the connector housings use an XACTO knife.
Plug Into RX Pass-Thru

Step #2:

Plug the 3P connector housing into the RX Pass-Thru™, black-black; white-white.
Plug Into microBRAKE LED Controller

Step #3:

Plug the separate power source positive (+) lead into the top pin of PWR, and the negative(-) lead into the bottom pin of PWR.

Plug the 2P connector housing from the modified 3 wire power plug into the AUX channel, black-top; white-bottom.
Plug Into RX

Step #4:

Plug the RX Pass-Thru™ into the receiver.

Tutorial Complete!

 

http://www.rc-lights.com/products/RCL5052.html