Directly power up to 10 LEDs.  Current limiting resistors are built right in.

10 CONSTANT LED CHANNELS SPLIT INTO 2 BANKS (6 CONSTANT, 4 CONSTANT)

Using the 10 LED Controller, LEDs can be directly powered using a variety of power sources.

Used with electronic switches, LEDs can be split into two independently controllable banks - LED1-6 and AUX1-4.

Usually LED1-6 is used for constants - headlights, running lights, navigation lights. Leaving AUX1-4 for auxiliary lights - brake lights, landing lights.

With the jumper installed on the AUX channel AUX1-4 are constant ON and electrically exactly the same as LED1-6.

The PWR channel can be used to power the controller or link power with additional controllers.

Bundled with these complete systems: #5004, #5004-E, #104, #106, #112, #5316

Includes

UPC# 813487010062

Specs

DIMENSIONS: 1.15" x 0.75" x 0.25"

INPUT VOLTAGE: 3.6-7.4V [6V Optimal]

TYP OUTPUT CURRENT (per LED channel): 20-30mA

Controller pins can be directly soldered to for DIY projects.  Use heat shrink to insulate each pin.

Limited Lifetime Warranty

Every RC-LIGHTS LED is guaranteed against manufacturer defect for the lifetime of the LED (10 TEN Years). All system components are guaranteed against manufacturer defect for 2 TWO Years after the original date of purchase.  Should your LED ever not light contact us immediately and a replacement will be sent right away. Warranty does not cover damage due to powering the LED beyond specified ratings. Warranty does not cover damage due to an incorrect installation. Warranty does not cover normal wear, abuse, neglect, or any damage arising as a result of improper use or modification.

Installation Instructions

Standard 10 LED Controller
Standard 10 LED Controller TECH SHEET
Dual RPS Tutorial
RPS + EBS Tutorial
RPS + Separate Power Source Tutorial
>>> SUPPORT INDEX <<<