Directly power up to 6 LEDs.  Current limiting resistors are built right in.

Using the microBRAKE™ 6 LED Controller, LEDs can be directly powered from the throttle channel of the RX using the included RX Pass-Thru™ (mini Y-harness).

Dual intensity brake light action is built right in!  Throttle channel input fully reversible.

LEDs are split into two banks: 4 constant; and 2 switched dim or full bright depending on throttle stick position (GAS or BRAKE.)

Throttle center-stick auto-detect for precise lighting effects every time.

All LINK channels have been eliminated to make a nice, compact little controller capable of the most common of needs for Car & Truck bodies.

Bundled with these complete systems: #5006 & #106-MB

NOTE: microBRAKE™ 6 LED Controller is not compatible with the Remote Power Switch (#5090).

Includes

UPC# 813487010680

Specs

DIMENSIONS: 1.3" x 0.6" x 0.3"

INPUT VOLTAGE: 3.6-7.4V [6V Optimal]

TYP OUTPUT CURRENT (per LED channel): 20-30mA

Controller pins can be directly soldered to for DIY projects.  Use heat shrink to insulate each pin.

Limited Lifetime Warranty

Every RC-LIGHTS LED is guaranteed against manufacturer defect for the lifetime of the LED (10 TEN Years). All system components are guaranteed against manufacturer defect for 2 TWO Years after the original date of purchase.  Should your LED ever not light contact us immediately and a replacement will be sent right away. Warranty does not cover damage due to powering the LED beyond specified ratings. Warranty does not cover damage due to an incorrect installation. Warranty does not cover normal wear, abuse, neglect, or any damage arising as a result of improper use or modification.

Installation Instructions

microBRAKE™ 6 LED Controller
microBRAKE™ 6 LED Controller TECH SHEET
microBRAKE™ + Separate Power Source Tutorial
>>> SUPPORT INDEX <<<