Directly power up to 14 LEDs. Current limiting resistors are built right in.

Using the NIGHTFLY™ 14 LED Controller, LEDs can be directly powered from the RX or an additional power source.

LEDs are split into five banks: 4 constant; 4 switched on/off depending on TX 2-pos switch position (Landing Lights); 2 fully-adjustable single strobes; 2 fully-adjustable single/double strobes; and 2 simulated rotating beacon lights (adjustable fast/slow).

The NIGHTFLY™ 14 LED Controller has two TX/RX signal inputs; one is for switching auxiliary (landing) lights on/off; the second is for switching power to the entire controller on/off. Each signal input should be plugged into an available RX channel tied to a 2-position switch on the TX. A Y-harness or RX Pass-Thru™ can be used on channels in use, but still provide the correct signals for switching (i.e. landing gear channel).

Link additional controllers using the extra set of PWR & AUX inputs.

Bundled with this complete system: #5324

Includes

UPC# 813487010789

Specs

DIMENSIONS: 1.65" x 1.0" x 0.25"

INPUT VOLTAGE: 3.6-7.4V [6V Optimal]

TYP OUTPUT CURRENT (per LED channel): 20-30mA

Controller pins can be directly soldered to for DIY projects.  Use heat shrink to insulate each pin.

Limited Lifetime Warranty

Every RC-LIGHTS LED is guaranteed against manufacturer defect for the lifetime of the LED (10 TEN Years). All system components are guaranteed against manufacturer defect for 2 TWO Years after the original date of purchase.  Should your LED ever not light contact us immediately and a replacement will be sent right away. Warranty does not cover damage due to powering the LED beyond specified ratings. Warranty does not cover damage due to an incorrect installation. Warranty does not cover normal wear, abuse, neglect, or any damage arising as a result of improper use or modification.

Installation Instructions

NIGHTFLY™ 14 LED Controller
NIGHTFLY™ 14 LED Controller TECH SHEET
NIGHTFLY™ + Separate Power Source Tutorial
>>> SUPPORT INDEX <<<