Directly power up to 3 LEDs.  Current limiting resistors are built right in.

Using the RX Direct2LED™, LEDs can be directly powered from any available channel on the RX (receiver). If no channels are available use a Y-harness or RX Pass-Thru™.

Used with electronic switches, LEDs can be run at dual-intensities or switched on/off from the TX (transmitter).

Bundled with these complete systems: #5412-E, #5422-E, #5499, #112, #5300, #5491

Includes

UPC# 813487010482

Specs

TYP OUTPUT CURRENT (per LED channel): 20-30mA

Controller pins can be directly soldered to for DIY projects.  Use heat shrink to insulate each pin..

Limited Lifetime Warranty

Every RC-LIGHTS LED is guaranteed against manufacturer defect for the lifetime of the LED (10 TEN Years). All system components are guaranteed against manufacturer defect for 2 TWO Years after the original date of purchase.  Should your LED ever not light contact us immediately and a replacement will be sent right away. Warranty does not cover damage due to powering the LED beyond specified ratings. Warranty does not cover damage due to an incorrect installation. Warranty does not cover normal wear, abuse, neglect, or any damage arising as a result of improper use or modification.

Installation Instructions

RX Direct2LED™ 3 LED Controller
Remote Power Switch
Electronic Brake Switch
>>> SUPPORT INDEX <<<